Engine Front
- Oil Level Thermal Sensor -G266-
- Overview. Refer to OVERVIEW - OIL PAN/OIL PUMP .
- Map Controlled Engine Cooling Thermostat -F265-
- Integrated in the oil filter housing; cannot be replaced separately
- Oil Temperature Sensor 2 -G664-
- Component location. Refer to
- Overview. Refer to OVERVIEW - BELT PULLEY SIDE SEALING FLANGE .
- Oil Pressure Switch -F22-
- Overview. Refer to OVERVIEW - OIL FILTER HOUSING/OIL PRESSURE SWITCH .
- Reduced Oil Pressure Switch -F378-
- Overview. Refer to OVERVIEW - OIL FILTER HOUSING/OIL PRESSURE SWITCH .
- EGR Cooler Switch-Over Valve -N345-
- Intake Flap Motor -V157-
- Overview. Refer to OVERVIEW - INTAKE MANIFOLD .
- Throttle Valve Control Module -J338-
- Overview. Refer to OVERVIEW - INTAKE MANIFOLD .
- Engine Temperature Control Sensor -G694-
- Component location.
- Oil Pressure Regulation Valve -N428-
- Component location. Refer to
- Overview. Refer to OVERVIEW - OIL PAN/OIL PUMP .
- A - Fuel Pump Control Module -J538-
- Component location.
- B - Reducing Agent Injector -N474-
- Only installed on vehicles with a Selective Catalytic Reduction System (SCR)
- Component location.
- Overview. Refer to appropriate service information.
- C - NOx Sensor 2 -G687- with NOx Sensor Control Module 2 -J881-
- Only installed on vehicles with a selective catalytic reduction system (SCR)
- Component location for vehicles with engine code CPNB
- Overview. Refer to OVERVIEW - HEATED OXYGEN SENSOR, VEHICLES WITH A TURBOCHARGER WITH A SCR-SYSTEM, VERSION 1 .
- D - NOx Sensor -G295- with NOx Sensor Control Module -J583-
- Only installed on vehicles with a selective catalytic reduction system (SCR)
- Component location.
- Overview. Refer to OVERVIEW - HEATED OXYGEN SENSOR, VEHICLES WITH A TURBOCHARGER WITH A SCR-SYSTEM, VERSION 1 .
- E - Reducing Agent Metering System Control Module -J880-
- Only installed on vehicles with a selective catalytic reduction system (SCR)
- F - Exhaust Gas Temperature Sensor 4 -G648-
- Only installed on vehicles with a selective catalytic reduction system (SCR)
- Component location
- Overview. Refer to appropriate service information.
- G - Exhaust Gas Temperature Sensor 2 -G448-
- Depending on the version installed on vehicles with a selective catalytic reduction system (SCR)
- Component location
- Overview. Refer to appropriate service information.
- H - Particulate Sensor -G784-
- Only installed on vehicles with a selective catalytic reduction system (SCR)
- Component location
- Overview. Refer to appropriate service information.
- Item -1- inside the plenum chamber on the left side.
- Inside the accelerator pedal module
The Accelerator Pedal Position Sensor -G79- and the Accelerator Pedal Position Sensor 2 -G185- are part of the accelerator pedal module and cannot be replaced separately.
Removing and installing. Refer to ACCELERATOR PEDAL POSITION SENSORS -G79- / -G185-, REMOVING AND INSTALLING .
- Inside the footwell at the brake pedal
Removing and Installing. Refer to appropriate service information. .
- The Fuel Pump Control Module -J538- -arrow- is level with the bench seat on the right side between the floor panel and the fuel tank.
The floor panel is shown cut open in the illustration.
Removing and installing. Refer to appropriate service information. .
- Item -2- in the rear and on the right side of the engine.
- Item -2- on the cylinder head cover on the cylinder bank 1 (right).
- Item -2- in the high pressure pump.
- Item -2- on left air guide pipe in the engine compartment.
Removing and installing. Refer to Charge Air Pressure Sensor -G31- / Intake Air Temperature Sensor -G42-, REMOVING AND INSTALLING .
- Item -1- on left front cylinder block.
Removing and installing. Refer to Engine Temperature Control Temperature Sensor -G694-, REMOVING AND INSTALLING .
Removing and installing. Refer to Engine Coolant Temperature Sensor on Radiator Outlet -G83-, REMOVING AND INSTALLING .
Reducing Agent Injector -N474- Not Water-Cooled
2 - Reducing Agent Injector -N474- Connector
Removing and Installing. Refer to appropriate service information.
Reducing Agent Injector -N474- Water-Cooled
2 - Reducing Agent Injector -N474-
Removing and Installing. Refer to appropriate service information.
- Exhaust Gas Temperature Sensor 3 -G495-
- Exhaust Gas Temperature Sensor 2 -G448-
- NOx Sensor -G295-
- Heated Oxygen Sensor -G39-
- Connector for Exhaust Gas Temperature Sensor 2 - G448-
- Exhaust Gas Temperature Sensor 3 -G495- connector
- Heated Oxygen Sensor -G39- connector
- NOx Sensor Control Module - J583- connector
- NOx Sensor -G295-
- NOx Sensor Control Module - J583-
- NOx Sensor Control Module 2 - J881- connector
- NOx Sensor 2 -G687-
- NOx Sensor Control Module 2 -J881-
- Particulate Sensor - G784- connector
- Particulate Sensor -G784-
- Particulate Sensor - G784- control module