Overview - Charge Air System, Vehicles With Two Turbochargers
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Charge Air Cooler
- Removing and installing. Refer to CHARGE AIR COOLER, REMOVING AND INSTALLING, VEHICLES WITH A TURBOCHARGER .
- Hose Clamp
- Tightening specification. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Air Guide Hose
- Must be free of oil and grease before installing
- Hose Clamp
- Tightening specification. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Bolt
- 9 Nm
- Right Air Guide Pipe
- From the turbocharger
- Bracket
- Grommet
- Sleeve
- Nut
- 9 Nm
- Bolt
- 9 Nm
- O-ring
- Replace
- Bolt
- 9 Nm
- Intermediate Pipe
- From the turbocharger
- Bolt
- 9 Nm
- O-ring
- Replace
- Hose clamp
- Tightening specification. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Air guide hose
- To the intake manifold
- Must be free of oil and grease before installing
- Hose clamp
- Tightening specification. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Bolt
- 9 Nm
- O-ring
- Replace
- Bolt
- 5 Nm
- Charge Air Pressure Sensor -G31- / Intake Air Temperature Sensor -G42-
- Removing and installing. Refer to Charge Air Pressure Sensor -G31- / Intake Air Temperature Sensor -G42-, REMOVING AND INSTALLING .
- Left air guide pipe
- Hose clamp
- Tightening specification. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Air guide hose
- Must be free of oil and grease before installing
- Hose clamp
- Tightening specification. Refer to OVERVIEW - CHARGE AIR HOSE CONNECTIONS .
- Bolt
- 7 Nm