LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 972 (Wiring System (Repairing - General Information)) >> 97 Wires >> Wiring Harness And Connector Repairs >> Connector Housings, Releasing And Disassembling >> Primary Lock

Primary Lock

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

The primary lock is the locking mechanism of an individual crimp contact in the connector housing.

If necessary, housing securing mechanisms (secondary locks) must be released or removed using specified tool before releasing the contacts. Refer to SECONDARY LOCK .

The shapes of the primary locks depicted in the following are only a selection which, as an example, should make clear the various functions of the primary lock.

The allocation of the correct release tool for the respective locks can be found in the table in the :VAS1978/35  Operating Instructions.

scientia non olet · About LEMON Manuals