Aerial Cable Repair Set Vas6720: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Checking the antenna wire. Refer to AERIAL CABLE REPAIR SET VAS6720

Replacing the tool head. Refer to AERIAL CABLE REPAIR SET VAS6720

Cutting the antenna wire. Refer to AERIAL CABLE REPAIR SET VAS6720

Removing the insulation from the shield. Refer to AERIAL CABLE REPAIR SET VAS6720

Removing the outer jacket of insulation: AERIAL CABLE REPAIR SET VAS6720

Removing the inner insulation. Refer to AERIAL CABLE REPAIR SET VAS6720

Crimping the inner conductor. Refer to AERIAL CABLE REPAIR SET VAS6720

Crimping the outer conductor. Refer to AERIAL CABLE REPAIR SET VAS6720

Special tools and workshop equipment required

Aerial Cable Repair Set:VAS6720

The :VAS6720 makes it possible to perform a quality repair on antenna wires RG 174 (blue) and RTK 031 (black). The set contains the insulation removal tools and the crimping tools for both antenna wires. Moreover, all the individual parts needed are in the kit. Only the zero-coded coupler (green) is needed. All other connection wires for the different Infotainment systems can be found in the parts information in table 035-XX. These adapter antenna wires must always be ordered separately depending on the vehicle type. All part numbers needed for reordering can be found in this table. The each compartment in the kit has a part number. The repair kit is based on the Wiring Harness Repair Set VAS1978B.

NOTE:

Additional information: :VAS6720 Operating Instructions.