RELAY PANEL MOUNT, REMOVING AND INSTALLING, UNDER DRIVER SIDE INSTRUMENT PANEL, Vehicle Electrical System Control Module -J519-: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the vehicle electrical system control module. Refer to Vehicle Electrical System Control Module -J519-, REMOVING AND INSTALLING .

-- Remove the headlamp range control module. Refer to HEADLAMP RANGE CONTROL MODULE, REMOVING AND INSTALLING .

-- Remove the left instrument panel vent. Refer to INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Slide the extension -2- from the socket set between the air duct -3- and the instrument panel.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts -4 and 5-.

-- Remove the mount -6- from the threaded pins.

-- Disengage the retaining pins -1- on the mount at the side guide in the A-pillar -arrow- while pulling the mount toward the passenger compartment.

-- Release the tabs -3- in direction of -arrow A- and disengage the mount for the headlamp range control module -1- from the mount -2- in direction of -arrow B-.

Courtesy of AUDI OF AMERICA, LLC