LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 971 (Wiring System (Service Information)) >> 97 Wiring >> Relay Panels, Fuse Panels And E-Boxes >> Relay And Fuse Panel Behind Instrument Panel On Driver Side, Removing And Installing >> RELAY PANEL MOUNT, REMOVING AND INSTALLING, UNDER DRIVER SIDE INSTRUMENT PANEL, Vehicle Electrical System Control Module -J519- >> Installing

RELAY PANEL MOUNT, REMOVING AND INSTALLING, UNDER DRIVER SIDE INSTRUMENT PANEL, Vehicle Electrical System Control Module -J519-: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

-- Engage the retaining pins -1- on the mount -3- at the side guide in the A-pillar -arrow-.

GWWA97-10457Courtesy of AUDI OF AMERICA, LLC

-- Tighten the nuts -2-.

scientia non olet · About LEMON Manuals