Fuse Panel D -SD-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the Battery -A- when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the driver side instrument panel cover. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING . .

-- Release the tab in direction of -arrow- and remove Fuse Panel D -SD- -2- from the relay panel -1- toward the rear.

Courtesy of AUDI OF AMERICA, LLC

-- Unlock the release and remove it from the fuse panel.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the fuses from the fuse panel.

-- Open the clips in direction of -arrows- and remove the fuse panel cover.

-- Pull off retaining strip -1- for the connectors in direction of -arrow- and remove the connectors from the plug-in socket

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Check the exact assignment in the current wiring diagram. Refer to the appropriate WIRING DIAGRAM.