Left A-Pillar Connector Station, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Disconnect the ground cable from the Battery -A- when the ignition is switched off. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the front sill panel. Refer to FRONT SILL PANEL STRIP, REMOVING AND INSTALLING or REAR SILL PANEL STRIP, REMOVING AND INSTALLING . .

-- Push the retainer in direction of -arrow- and disengage the connector station -3- from the A-pillar.

Courtesy of AUDI OF AMERICA, LLC

-- Unclip the fuse panel from the connector station.

-- Remove the mount -2- for the 46-Pin Connector -T46b-. Refer to CAN CUT-OFF CONNECTOR MOUNT, REMOVING AND INSTALLING .

NOTE:

Ignore -1-.

-- Open the clip and remove the auxiliary fuse panel -2-.

Courtesy of AUDI OF AMERICA, LLC

-- Release the clips in direction of -arrows- and remove the relay -1- and the control modules from the relay panels.

-- Open the clips in direction of -arrows- and press the relay panel -3- toward the rear and out of the bracket -4-.

Courtesy of AUDI OF AMERICA, LLC

-- Open the clip -2- and remove the connector terminal -1- from the bracket.

NOTE:

Check the exact assignment in the current wiring diagram. Refer to the appropriate WIRING DIAGRAM.