Overview - Steering Column Switch Module
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition Key
- Screw
- 0.5 Nm
- Transportation Protection
- Steering Column Electronics Control Module -J527-
- With Airbag Spiral Spring/Return Spring with Slip Ring -F138-, Steering Angle Sensor -G85-
- Removing and installing. Refer to Steering Column Electronics Control Module -J527-, REMOVING AND INSTALLING .CAUTION:
Risk of damaging the return ring.
- The return spring with slip ring must not be turned after removing.
- Pin assignment for the Steering Column Electronics Control Module -J527-. Refer to STEERING COLUMN ELECTRONICS CONTROL MODULE CONNECTOR ASSIGNMENT .
- Mount
- With Turn Signal Switch -E2-, Windshield Wiper Intermittent Mode Switch -E22-
- On vehicles with cruise control with a Cruise control switch -E45-
- Removing and installing. Refer to STEERING COLUMN COMBINATION SWITCH, REMOVING AND INSTALLING .
- Steering Column
- Locking Ring
- Bolt
- 6 Nm
- Anti-Theft Immobilizer Reader Coil -D2-
- Removing and installing. Refer to Anti-Theft Immobilizer Reader Coil -D2-, REMOVING AND INSTALLING .
- Mount
- For Anti-Theft Immobilizer Reader Coil -D2-
- Removing and installing. Refer to Anti-Theft Immobilizer Reader Coil -D2- MOUNT, REMOVING AND INSTALLING .
- Bolt
- 3 Nm
- Bolt
- 3 Nm