LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 968 (Seats System (Frames- Service Information - 1 Of 2)) >> Seat Frames >> Front Seats >> Seat Pan, Disassembling And Assembling >> Seat Side Trim On Sill Panel Side, Removing And Installing, Front Seat (Power) >> Installing

Seat Side Trim On Sill Panel Side, Removing And Installing, Front Seat (Power): Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

NOTE:

Make sure the connectors are installed correctly and are secure.

Route the connectors and wires as illustrated.

Make sure the trim on the sill side is correctly attached to the mounting bracket.

Information for installation: for example, tightening specifications, replacing body parts. Refer to OVERVIEW - SEAT PAN, SILL PANEL/TUNNEL SIDE SEAT SIDE TRIM  and OVERVIEW - SEAT PAN, SEAT SIDE TRIM BRACKET ON SILL PANEL SIDE .

scientia non olet · About LEMON Manuals