Seat Depth Adjuster, Removing And Installing, Multi-Contour Seat: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Lower the front seat all the way down and then raise approximately 1/3.

-- Move seat depth adjuster forward.

-- Remove the front seat. Refer to FRONT SEAT, REMOVING AND INSTALLING .

-- Fasten the front seat on the :VAS6136 . Refer to FRONT SEAT, MOUNTING ON FIXTURE FOR SEAT REPAIR .

-- Remove front trim bracket, compressor and Multi-contour seat control module. Refer to FRONT SEAT TRIM BRACKET/COMPRESSOR/CONTROL MODULE, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .

-- Remove seat cover and seat cushion. Refer to SEAT PAN COVER AND CUSHION, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .

Courtesy of AUDI OF AMERICA, LLC

-- Release latches -arrows- with a screwdriver and remove depth adjustment motor carrier -1-

-- Unclip the cover -1- from the lower seat frame -A arrows-, disengage is from the seat depth adjuster -arrows B- and remove it.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect and free up the connector -3-.

Courtesy of AUDI OF AMERICA, LLC

-- Remove the screws -1 and 4- and the seat depth adjuster motor -2-.

-- Remove the screws -1- and move the seat angle adjustment motor -4- to the side.

Courtesy of AUDI OF AMERICA, LLC