Front Seat Trim, Sill Panel/Tunnel Seat Side Trim, Multi-contour Seat
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Front Trim
- Removing and installing. Refer to SEAT SIDE TRIM ON SILL PANEL SIDE/FRONT SEAT TRIM, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .
- Bracket
- For front trim, compressor and Multi-contour seat control module
- Removing and installing. Refer to FRONT SEAT TRIM BRACKET/COMPRESSOR/CONTROL MODULE, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .
- To replace, install the compressor for the Multi-contour seat into the new bracket
- Expanding Rivet
- Bolt
- 6.5 Nm
- Clean the threaded hole with a thread tap.
- Install with locking compound. For the correct locking compound. Refer to the Parts information.
- Tunnel-Side Trim
- Removing and installing. Refer to SEAT SIDE TRIM ON THE TUNNEL SIDE, REMOVING AND INSTALLING .
- Front Seat
- Bracket
- For sill side trim
- Removing and installing. Refer to SEAT SIDE TRIM ON SILL PANEL SIDE/FRONT SEAT TRIM, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .
- Bolt
- 8 Nm
- Quantity: 2
- Sill-Side Trim
- Removing and installing. Refer to SEAT SIDE TRIM ON SILL PANEL SIDE/FRONT SEAT TRIM, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .
- Lock into the bracket and to the trim
- Bolt
- 3.5 Nm
- Quantity: 2
- Threaded holes for bolts must be cleaned, for example, with a thread tap
- Install with locking compound. For the correct locking compound. Refer to the Parts information.