Overview - Seat Pan, Seat Forward/Back Adjustment: Notes
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Seat Forward/Back Adjustment (Manual). Refer to OVERVIEW - SEAT PAN, SEAT FORWARD/BACK ADJUSTMENT
Seat Forward/Back Adjustment (Power), Standard Seat/Sport Seat/Super Sport Seat. Refer to OVERVIEW - SEAT PAN, SEAT FORWARD/BACK ADJUSTMENT
Seat Forward/Back Adjustment, Multi-contour Seat. Refer to OVERVIEW - SEAT PAN, SEAT FORWARD/BACK ADJUSTMENT
Seat Forward/Back Adjustment (Manual)
NOTE:
To repair the seat forward/back adjustment, there is a repair kit available. Refer to the Parts information.
- Front Seat
- Seat Forward/Back Adjuster
- Unit with seat upper section (seat pan)
- Cannot be replaced separately. For the repair kit. Refer to the Parts information.
- Servicing. Refer to SEAT FORWARD/BACK ADJUSTMENT, SERVICING .
- Seat Forward/Back Adjuster Release Cable
- Removing and installing. Refer to SEAT FORWARD/BACK ADJUSTMENT RELEASE CABLE, REMOVING AND INSTALLING .
- It is not possible to adjust the release cable
- Clip or Cable Tie
- Handle
- For seat forward/back adjustment
- Removing and installing. Refer to SEAT FORWARD/BACK ADJUSTMENT HANDLE, REMOVING AND INSTALLING .
- Must lock with the clip
- Clip
- Replace
- Installed position. Refer to
- Actuator
- For seat forward/back adjustment
- Spring
- For lever for seat forward/back adjuster release cable retainer
- Different components for driver and front passenger side
- Removing and installing. Refer to RELEASE CABLE RETAINER/SEAT FORWARD/BACK ADJUSTMENT LEVER AND SPRING, REMOVING AND INSTALLING .
- Lever
- For seat forward/back adjuster release cable retainer
- Same part for driver and front passenger seat
- Removing and installing. Refer to RELEASE CABLE RETAINER/SEAT FORWARD/BACK ADJUSTMENT LEVER AND SPRING, REMOVING AND INSTALLING .
- The springs -arrows- (quantity: two) on the clip -2- must be on the inner side of the lever -1-.