Overview - Front Backrest, Multi-Contour Seat

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Front Backrest, Multi-Contour Seat Exploded View

Courtesy of AUDI OF AMERICA, LLC

Seat Pan
Bolt
- 34.5 Nm
- Quantity: 4
- Self-locking
- Replace
- Threaded holes for bolts must be cleaned, for example, with a thread tap
Trim
- for backrest hinge trim on tunnel side
- Removing and installing. Refer to FRONT BACKREST, REMOVING AND INSTALLING .
Backrest
- Removing and installing. Refer to FRONT BACKREST, REMOVING AND INSTALLING .
Headrest
- Removing and installing. Refer to HEADREST, REMOVING AND INSTALLING .
Clip
- With hooks
- Quantity: 2
- Replace
- Insert into the backrest cover
- Remove any remaining clips in the backrest frame mounting points using the Omega Clip Tool:T40280 .
- Replace damaged or deformed clips
Backrest Cover
- Removing and installing. Refer to BACKREST COVER, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .
Rubber Strap
- With hooks
- Quantity: 2
Trim
- For sill side backrest hinge
- Removing and installing. Refer to FRONT BACKREST, REMOVING AND INSTALLING .
Expanding Rivet
Wiring Harness
- from the side airbag to the connector station
- Depending on the vehicle version, there may be more wiring harnesses, such as for the backrest heating
Bolt
- 10 Nm
Belt Guide
- Removing and installing. Refer to FRONT SEAT BELT GUIDE, REMOVING AND INSTALLING, MULTI-CONTOUR SEAT .