Seat Heating Control Module -J882-, REMOVING AND INSTALLING: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the rear bench seat. Refer to SEAT BENCH/SINGLE SEAT, REMOVING AND INSTALLING .
-- Slightly lift the sill panel strip above the control module -3- and disengage the control module with the bracket -1- from the wiring guide -arrow-.
NOTE:
In addition, the mount for the control module is bonded to the body with an adhesive pad.
-- Disconnect the connector -2- and remove the seat heating control module.