LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 966 (Seats System (Frames- Service Information - 2 Of 2)) >> Seat Frames >> Rear Seats >> Seat Bench/Single Seat, Removing And Installing >> Seat Heating Control Module -J882-, REMOVING AND INSTALLING >> Installing

Seat Heating Control Module -J882-, REMOVING AND INSTALLING: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA72-11635Courtesy of AUDI OF AMERICA, LLC

-- Install the control module -1- into the bracket -2- and remove the protective backing from the adhesive pad -3-.

-- Install the control module with the mount into the wiring guide and press it forcefully to the body.

Installation is performed in reverse order of removal, while noting the following:

scientia non olet · About LEMON Manuals