LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 966 (Seats System (Frames- Service Information - 2 Of 2)) >> Seat Frames >> Rear Seats >> Rear Seat Backrest, Removing And Installing >> Mount/Sleeve/Pins, Removing And Installing, Rear Seat Backrest >> Remove Inner Mounting Pin

Remove Inner Mounting Pin

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
GWWA72-10647Courtesy of AUDI OF AMERICA, LLC

-- Remove the chafe protection -4- and then remove the mounting pin -3- from the rear seat backrest frame -1-.

NOTE:

The cushion and cover are not shown in the illustration.

-- Remove the bearing sleeve -2- from the mounting pin.

scientia non olet · About LEMON Manuals