Locking Mechanism Trim, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Unlock the rear seat backrest.
-- Make sure the button -2- (indicator) is in the >>up<< position.
-- Push the tabs -arrows- on both sides of the trim using a :3409 .
-- Remove the trim -1- upward and off the rear seat backrest -3-.
-- Remove the trim -1- as far as possible upward from the rear seat backrest.
-- Pry the catch -arrow- out of the locking mechanism using a flat blade screwdriver.
-- Remove the trim upward from the rear seat backrest.
NOTE:
The catch on the predetermined breaking point -arrow- must be destroyed after removing the trim and lock cylinder.