Pass-Through Door Lock Cylinder, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
CAUTION:
- Only remove and install the lock cylinder with the key inserted correctly. If that is not done, the tumblers and compression springs can fall out and the lock cylinder will be ruined.
- Check the installation position when installing the lock cylinder. It is not possible to lock the backrest correctly if the installation position is not correct.
-- Slide the lock -3- into the new lock cylinder -2- correctly.
-- Remove the cap -4- from the new lock cylinder.
-- Insert the lock cylinder into the pass-through door handle -1-. Pay attention to the installed position.
-- Turn the key 90° clockwise.
- Installation position of the lock cylinder: the key slot must be vertical and the retaining tab -arrow- must point to the right, opposite the direction of travel.