Overview - Valve Block/Module Carrier/Lumbar Support/Fan, Multi-Contour Seat Through 08/2012
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Driver Seat Backrest Blower Fan -V388-
- Front passenger side: Front Passenger Seat Backrest Blower Fan -V389-
- Removing and installing. Refer to FRONT BACKREST FAN, REMOVING AND INSTALLING .
- Rubber Bracket
- For blower fan
- Quantity: 4
- Boot
- bonded with backrest padding
- Module Carrier
- Module carrier with air cushions for lumbar support
- Cannot be disassembled
- Removing and installing. Refer to MODULE CARRIER WITH AIR CUSHIONS FOR LUMBAR SUPPORT, REMOVING AND INSTALLING, THROUGH 08/2012 .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Rubber Bushing
- For multi-contour seat control module
- Quantity: 3
- Driver Multi-contour Seat Control Module -J873-
- Front passenger side: Front Passenger Multi-contour Seat Control Module -J872-
- The connection for the restrictor is deleted on the Original Replacement Part with an integrated check valve and the separate check value must be removed. Refer to the Parts information.
- Removing and installing. Refer to MULTI-CONTOUR SEAT CONTROL MODULE, REMOVING AND INSTALLING, THROUGH 08/2012 .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Backrest Frame
- Bolt
- 6.5 Nm
- Plastic Washer
- Insert in front of the lumbar support bolting between lumbar support bracket and backrest frame