Overview - Valve Block/Module Carrier/Lumbar Support/Fan, Multi-Contour Seat From 09/2012
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Boot
- Bonded with backrest padding
- Air Cushion for Lumbar Support
- Removing and installing. Refer to MODULE CARRIER, AIR CUSHION FOR LUMBAR SUPPORT, REMOVING AND INSTALLING, FROM 09/2012 .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Expanding Rivet
- Quantity: 4
- Module Carrier
- For module carrier with air cushions for lumbar support
- Removing and installing. Refer to MODULE CARRIER, AIR CUSHION FOR LUMBAR SUPPORT, REMOVING AND INSTALLING, FROM 09/2012 .
- Rubber Buffer
- Valve block mount
- Quantity: 4
- Valve Block 1 in Driver Seat -N475-
- Front passenger side: Valve Block 1 in Front Passenger Seat -N477-
- For lumbar support and side wall adjuster
- Removing and installing. Refer to VALVE BLOCK FOR AIR CUSHION FOR LUMBAR SUPPORT, SEAT AND BACKREST BOLSTER ADJUSTER ASSEMBLY, REMOVING AND INSTALLING, FROM 09/2012 .
- Connect the pneumatic lines. Refer to PNEUMATIC LINES, DISCONNECTING AND CONNECTING
- Backrest Frame
- Rubber Bracket
- For blower fan
- Quantity: 4
- Driver Seat Backrest Blower Fan -V388-
- Front passenger side: Front Passenger Seat Backrest Blower Fan -V389-
- Removing and installing. Refer to FRONT BACKREST FAN, REMOVING AND INSTALLING .
- Bolt
- 6.5 Nm
- Plastic Washer
- Insert in front of the lumbar support bolting between lumbar support bracket and backrest frame