LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 962 (Climate Control System (Service Information - (Front Heater & A/C Unit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Front Heater And A/C Unit >> Auxiliary Heater Heating Element -Z35-, REMOVING AND INSTALLING >> Tightening Specifications

Tightening Specifications

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Clean the heating element area in the shaft before installing.

After completing the repair work, perform the following operations on the control head using the Vehicle Diagnostic Tester in the "Guided Fault Finding" function:

-- Check the Diagnostic Trouble Code (DTC) memory and delete any currently displayed entries.

-- Check the activation and the functionality via the Engine Control Module (ECM).

scientia non olet · About LEMON Manuals