LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 962 (Climate Control System (Service Information - (Front Heater & A/C Unit) CAEB, CGXB, CEUC, CTUA, CEUC, CAED, CHJA, CPNB, CRDB, CPNB, CREC, CTGE, CYNB, CWUC, CREH, CWUB)) >> Air Conditioning >> Air Guide >> Air Distribution Channels, Removing And Installing >> B-Pillar Vent Air Guide, Removing And Installing >> Removing

B-Pillar Vent Air Guide, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the front seat to the forward and most elevated position.

-- Remove the B-pillar air guide. Refer to B-PILLAR AIR GUIDE, REMOVING AND INSTALLING .

-- Remove the center console. Refer to Center Console .

-- Remove the rear bench seat. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

-- Carefully lift up the floor covering.

NOTE:

Make sure to not rip the carpet at the cut-outs.

The left side is shown in the illustration.

-- Loosen the air guide -2- from the retainer -1- and remove it from the air guide -3- for the rear air guide channel.

GWWA87-11062Courtesy of AUDI OF AMERICA, LLC

-- Loosen the air guide -1- for the rear air guide channel -3- out of the retainer and remove it.

GWWA87-11063Courtesy of AUDI OF AMERICA, LLC