Overview - Front Sill Panel Strip
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- Clip
- Quantity: 4
- Insert in the trim panel
- Remove the clips that are still in the mounting points on the body using Omega Clip Tool :T40280 .
- Replace damaged or deformed clips
- Clip
- Install into the gap cover
- Remove any remaining clips in the body mounting points using the Omega Clip Tool:T40280 . To install, insert into the gap cover.
- Replace any damaged or deformed clips
- A-Pillar Gap Cover
- Engage into the upper A-pillar trim
- Removing and installing. Refer to A-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
- Bolt
- 2.5 Nm
- Driver side only
- Release Lever
- Hood release cable
- Driver side only
- Removing and installing. Refer to LATCH RELEASE LEVER, REMOVING AND INSTALLING .
- Front Sill Panel Strip
- Removing and installing. Refer to FRONT SILL PANEL STRIP, REMOVING AND INSTALLING .