Overview - D-Pillar Trim Panel, AVANT

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of D-Pillar Trim Panel, Avant

Courtesy of AUDI OF AMERICA, LLC

Bolt
- 2 Nm
Driver
- For luggage compartment cover
- Only for vehicles with luggage compartment cover motor
- Clip into the guide rails for the luggage compartment cover
Clip
- Quantity: 1 or 2 depending on the equipment level
- Insert in the trim panel
- Remove any remaining clips in the body mounting points using the Omega Clip Tool :T40280 . To install, insert into the trim panel.
- Replace damaged or deformed clips
Bolt
- 2 Nm
D-Pillar Trim Panel
Vehicles With:
- Without luggage compartment cover motor
- With luggage compartment cover motor
- Removing and installing. Refer to D-PILLAR TRIM PANEL, REMOVING AND INSTALLING, AVANT .
- Press on until it engages audibly
- Stretch the rear lid seal lip