LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 960 (Interior Trim System (Service Information)) >> Interior Trim >> Instrument Panel >> Instrument Panel, Removing And Installing >> Removing

Instrument Panel, Removing And Installing: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

-- Move the steering wheel as far to the rear and down as possible. Use the full steering column adjustment range for this.

-- Move the front seats all the way back and tilt backrests 45°.

WARNING:

-- Disconnect the battery ground cable with the ignition turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .

-- Remove the Driver Side Airbag. Refer to AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .

-- Remove the Steering Wheel. Refer to STEERING WHEEL, REMOVING AND INSTALLING .

-- Remove the instrument panel cover on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING .

-- Remove the instrument panel vent on the driver side. Refer to DRIVER SIDE INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Remove the instrument panel vent on the front passenger side. Refer to PASSENGER SIDE INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Remove the center instrument panel vent. Refer to CENTER INSTRUMENT PANEL VENT, REMOVING AND INSTALLING .

-- Remove the instrument cluster. Refer to INSTRUMENT CLUSTER FRAME, REMOVING AND INSTALLING .

-- Remove the instrument cluster. Refer to OVERVIEW - INSTRUMENT CLUSTER .

-- Remove the Front Information Display Control Head -J685-. Refer to INFOTAINMENT SYSTEM DISPLAY, REMOVING AND INSTALLING .

-- Remove the Climatronic Control Module -J255-. Refer to CLIMATRONIC CONTROL MODULE -J255-, REMOVING AND INSTALLING .

-- Remove the Information Electronics Control Module 1 -J794-. Refer to INFORMATION ELECTRONICS CONTROL MODULE 1 -J794-, REMOVING AND INSTALLING .

-- Remove the upper instrument panel cover. Refer to INSTRUMENT PANEL UPPER COVER, REMOVING AND INSTALLING .

-- Remove the instrument panel center speaker. Refer to CENTER SPEAKER, REMOVING AND INSTALLING .

-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

-- Country-specific with knee airbag: remove the knee airbag bracket. Refer to KNEE AIRBAG BRACKET, REMOVING AND INSTALLING .

WARNING:

Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.

-- Disconnect the connectors for the front passenger airbag. Refer to FRONT PASSENGER AIRBAG UNIT WITH IGNITER, REMOVING AND INSTALLING .

-- Remove the Anti-Theft Immobilizer Reader Coil -D2-. Refer to ANTI-THEFT IMMOBILIZER READER COIL -D2-, REMOVING AND INSTALLING .

-- Vehicles with windshield projection head up display: remove the screws -1, 2 and 5- and the Windshield Projection Head Up Display Control Module -J898- loose with the instrument panel.

GWWA90-10129Courtesy of AUDI OF AMERICA, LLC

-- To do this, slightly lift the control module -3- out and disconnect the connector -4-.

-- Remove the bolts -1 through 4- for instrument panel on the driver side instrument panel crossmember.

GWWA70-11363Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 4- for instrument panel on the front passenger side instrument panel crossmember.

GWWA70-11364Courtesy of AUDI OF AMERICA, LLC

-- Remove the instrument panel bolts -1- on the center of the instrument panel crossmember.

GWWA70-11570Courtesy of AUDI OF AMERICA, LLC
NOTE:

Two technicians are needed to remove the instrument panel.

-- Disengage the bottom of the instrument panel from the bracket -2- -arrows- at the same time.

-- Disconnect the connectors and free up the wiring harnesses.

-- Carefully pull the instrument panel back from the instrument panel crossmember.

-- Remove the instrument panel from the vehicle interior and lay it on a soft surface.