CROSSMEMBER On Knee Airbag Bracket

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Crossmember On Knee Airbag Bracket

Courtesy of AUDI OF AMERICA, LLC

Bolt
- Quantity: 4
- Tightening Specification. Refer to OVERVIEW - KNEE AIRBAG, DRIVER SIDE .
Bracket
- for the driver knee airbag
- Removing and installing. Refer to DRIVER SIDE KNEE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .
Crossmember
- For the instrument panel
- Removing and installing. Refer to INSTRUMENT PANEL CROSSMEMBER, REMOVING AND INSTALLING .
Right Bracket
- For the knee airbag
- Removing and installing. Refer to KNEE AIRBAG BRACKET, REMOVING AND INSTALLING .
- Install the bracket and rubber grommet into the mount
Bolt
- 9 Nm
Left Bracket
- For the knee airbag
- Removing and installing. Refer to KNEE AIRBAG BRACKET, REMOVING AND INSTALLING .
- Install the bracket and rubber grommet into the mount
Support
- For the knee airbag
- Removing and installing. Refer to PASSENGER SIDE KNEE AIRBAG WITH IGNITER, REMOVING AND INSTALLING .
Bolt
- Tightening Specification. Refer to OVERVIEW - GLOVE COMPARTMENT .
Bolt
- 9 Nm