LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 959 (Airbags And Restraint Systems (Service Information)) >> Passenger Protection, Airbags, Seat Belts >> Passenger Occupant Detection System >> Passenger Occupant Detection System, Removing And Installing >> Notes

Passenger Occupant Detection System, Removing And Installing: Notes

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:

The passenger occupant detection system is only installed in the front passenger seat.

WARNING:

The replacement part (Service Kit) for the passenger occupant detection system (country-specific) is already pre-installed. Never disconnect the connector between the Passenger Occupant Detection System Control Module -J706- and the Passenger Occupant Detection System Pressure Sensor -G452-. The Service Kit differs depending on the seat version and consists of:

Standard seat/sport seat/super sport seat: 

  • Seat cushion with/without a seat heating element
  • The Passenger Occupant Detection System Pressure Sensor -G452- is attached to the seat cushion.
  • Passenger Occupant Detection System Control Module -J706-

Multi-contour seat: 

  • Passenger Occupant Detection System Pressure Sensor -G452- sewn in with seat heating element in the seat cover
  • Passenger Occupant Detection System Control Module -J706-
scientia non olet · About LEMON Manuals