Passenger Occupant Detection System, Removing And Installing: Installing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
Before handling pyrotechnic components (for example, connecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

Installation is performed in reverse order of removal, while noting the following:

NOTE:

Make sure the connectors are installed correctly and are secure.

WARNING:

Ignition must be on when connecting battery. If pyrotechnic components (for example, airbag, belt tensioner) are not repaired correctly, they may deploy unintentionally after connecting battery. There must not be anyone inside the vehicle when connecting the battery.

CAUTION:

When working on vehicles with the ignition already switched on or that are ready to drive there is a danger of the engine starting unexpectedly and of being poisoned by gas in enclosed areas. Risk of body parts and/or clothing being clamped or pulled.

Perform the following before switching on the ignition:

Move the selector lever into P.
Activate the parking brake
Turn off the ignition.
Open the hood
Connect the charger, such as the :VAS5095A to the jump start of the 12V vehicle electrical system.
Turn on the ignition.

-- Connect the battery GND cable with the ignition turned on. Refer to BATTERY .

When installing a new service kit and after each repair on the front passenger seat where the seat and/or the backrest cover is >>disengaged<<, a basic setting procedure must be performed on the passenger occupant detection system control module. Refer to ADDITIONAL SAFETY PRECAUTIONS - PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION, MARKET-SPECIFIC .

-- Select "airbag" in "Guided Fault Finding" to complete. Refer to Vehicle Diagnostic Tester.

-J706 passenger occupant detection system control module basic setting

NOTE:

If the Airbag Indicator Lamp -K75- signals a fault after installing, check the Diagnostic Trouble Code (DTC) memory, erase it and check it again. Refer to Vehicle Diagnostic Tester.