LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 959 (Airbags And Restraint Systems (Service Information)) >> Passenger Protection, Airbags, Seat Belts >> Passenger Occupant Detection System >> Component Location Overview - Passenger Occupant Detection System >> Overview - Passenger Occupant Detection System

Overview - Passenger Occupant Detection System

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Passenger Occupant Detection System Exploded View
GWWA72-11443Courtesy of AUDI OF AMERICA, LLC
  1. Bolt
    • 1.5 Nm
  2. Connector
    • Between the connector station under the seat and the Passenger Occupant Detection System Control Module -J706-.
  3. Bracket
  4. Pin
    • for securing the bracket to the seat pan
  5. Front Seat
  6. Passenger Occupant Detection System Pressure Sensor -G452-
    CAUTION:
    • Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.
    • Never disconnect the passenger occupant detection sensor from the seat cushion or the seat cover.
    • Different versions:
      • Standard seat/sport seat/super sport: the passenger occupant detection sensor is glued to the seat cushion
      • Multi-contour seat: the Multi-contour seat and seat heating element are sewn inside the seat cover
    • Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
  7. Connector
    • Between Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
      CAUTION:

      Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.

  8. Passenger Occupant Detection System Control Module -J706-
    • clipped with the bracket
      CAUTION:

      Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.

    • Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
scientia non olet · About LEMON Manuals