Component Location Overview - Passenger Occupant Detection System

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

The replacement part (Service Kit) for the passenger occupant detection system (country-specific) is already pre-installed. Never disconnect the connector between the Passenger Occupant Detection System Control Module -J706- and the Passenger Occupant Detection System Pressure Sensor -G452-. The Service Kit differs depending on the seat version and consists of:

Standard seat/sport seat/super sport seat:

Seat cushion with/without a seat heating element
The Passenger Occupant Detection System Pressure Sensor -G452- is attached to the seat cushion.
Passenger Occupant Detection System Control Module -J706-

Multi-contour seat:

Passenger Occupant Detection System Pressure Sensor -G452- sewn in with seat heating element in the seat cover
Passenger Occupant Detection System Control Module -J706-

WARNING:

Follow all safety precautions when working on the passenger occupant detection system. Refer to ADDITIONAL SAFETY PRECAUTIONS - PASSENGER OCCUPANT DETECTION SYSTEM DEACTIVATION, MARKET-SPECIFIC .

NOTE:

The passenger occupant detection system is only installed in the front passenger seat.

Courtesy of AUDI OF AMERICA, LLC

Connector
- Between Passenger Occupant Detection System Pressure Sensor -G452- and Passenger Occupant Detection System Control Module -J706-
  CAUTION:
  Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.
Connector
- Between the connector station under the seat and the Passenger Occupant Detection System Control Module -J706-.
Passenger Occupant Detection System Control Module -J706-
- There are different versions. For the correct allocation. Refer to the Parts information.
  CAUTION:
  Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .
Front Passenger Seat Belt Switch -E25- and Passenger Occupant Detection System Seat Belt Force Sensor -G453-
- Removing and installing. Refer to FRONT SEAT BELT LATCH, REMOVING AND INSTALLING .
Front Passenger Airbag -Disabled- Indicator Lamp -K145-
- Removing and installing. Refer to appropriate service information. .
Airbag Control Module -J234-
- Removing and installing. Refer to Airbag Control Module -J234-, REMOVING AND INSTALLING .
Connector Station
- Under the seat
- Connector assignment. Refer to the Appropriate Wiring Diagram.
- Connectors, disconnecting and connecting. Refer to AIRBAG ADAPTER, CONNECTING AND DISCONNECTING .
Passenger Occupant Detection System Pressure Sensor -G452-
- Different versions:
  - Standard seat/sport seat/super sport: the passenger occupant detection sensor is glued to the seat cushion
  - Multi-contour seat: the Multi-contour seat and seat heating element are sewn inside the seat cover
  CAUTION:
  - Do not disconnect the connector between the Passenger Occupant Detection System Pressure Sensor -G452- and the Passenger Occupant Detection System Control Module -J706-.
  - Never disconnect the passenger occupant detection sensor from the seat cushion or the seat cover.
- Removing and installing. Refer to PASSENGER OCCUPANT DETECTION SYSTEM, REMOVING AND INSTALLING .