Passenger Side Knee Airbag With Igniter, Removing And Installing: Removing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
- Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Follow all regulations when disposing of pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING (PYROTECHNIC COMPONENTS) .
-- Disconnect the battery Ground (GND) cable with the ignition turned on. Refer to BATTERY .
-- Remove the glove compartment. Refer to GLOVE COMPARTMENT, REMOVING AND INSTALLING, WITH KNEE AIRBAG .
-- Remove the nut -2- and the bolt -3-.
-- Remove the nut -5- with the connection for the ground cable and then remove the knee airbag support -6-.
-- Remove the bolt -4-.
-- Remove the front passenger knee airbag -1-.
WARNING:
Set the airbag down so the impact cushion faces upward.