Airbag Control Module -J234-, REMOVING AND INSTALLING: Removing

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

WARNING:

Follow all Safety Precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .

-- Disconnect the battery Ground (GND) cable with the ignition turned on. Refer to BATTERY .

-- Remove the center console. Refer to CENTER CONSOLE, REMOVING AND INSTALLING .

-- Remove the bracket for the center console. Refer to CENTER CONSOLE BRACKET, REMOVING AND INSTALLING .

-- Remove the rear air guide channel. Refer to REAR AIR GUIDE CHANNEL, REMOVING AND INSTALLING [For engine(s) CTUA, CAED, CREH, CEUC, CTGE, CREC, CYNB, CPNB] .

-- Fold up the floor covering over the airbag control module. Cut the floor covering along the perforation if necessary.

Courtesy of AUDI OF AMERICA, LLC

WARNING:

Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". This can be done by touching the door striker, for example.

-- Slide the retainer -7- on the connector in direction of -arrow-.

-- Press the release button -6-, opening the retainer -5- on the connector and remove the connector -4-.

-- Remove the nuts -1 through 3- and remove the airbag control module -A- from the threaded pins.