Mechatronic, Transmission Control Module -J217-, Sensor and Pressure Regulating Valves - Part 2

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

Transmission Input Speed Sensor -G182-
Transmission Control Module -J217-
Transmission Fluid Temperature Sensor -G93-
Drive Position Sensor -G676-

NOTE:

OBD checks all the components named.

Only the complete "Mechatronic" unit can be replaced.

Removing and Installing. Refer to appropriate service information. .

Courtesy of AUDI OF AMERICA, LLC

Removing and Installing. Refer to appropriate service information. .

Courtesy of AUDI OF AMERICA, LLC

Component location: The Selector Lever Sensor System Control Module -J587- and the Tiptronic Switch -F189- are a single unit -2-, which is clipped to the selector mechanism function unit -arrows-.

Removing and installing. Refer to Selector Lever Sensor System Control Module -J587-, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

Component location: The Shift Lock Solenoid -N110- -1- is clipped to the selector mechanism.

Removing and installing. Refer to Shift Lock Solenoid -N110-, REMOVING AND INSTALLING .

Courtesy of AUDI OF AMERICA, LLC

Component location: The Transmission Park Selector Switch -F305-, which consists of two reed contacts -1 and 2-, is installed on the circuit board -B- on the Shift Lock Solenoid -N110- -A-.

NOTE:

The Transmission Park Selector Switch -F305- can only be replaced together with the Shift Lock Solenoid -N110-.

Courtesy of AUDI OF AMERICA, LLC

Installed location: The Transmission Coolant Valve -N488- -1- is located on the back of the subframe on the left side.

Connector

Removing and installing. Refer to COOLANT VALVES, REMOVING AND INSTALLING [For engine(s) CYNB] or or COOLANT VALVE, REMOVING AND INSTALLING [For engine(s) CTGE, CEUC] or COOLANT VALVE, REMOVING AND INSTALLING [For engine(s) CPNB] or COOLANT VALVE, REMOVING AND INSTALLING For engine(s) CREC, CREH] or .

Courtesy of AUDI OF AMERICA, LLC

Installed location: the Transmission Range Display -Y6- -arrow- is integrated inside the instrument cluster.

NOTE:

Replace the instrument cluster if one of the transmission range displays is faulty. Refer to INSTRUMENT CLUSTER .

Courtesy of AUDI OF AMERICA, LLC

Component location: The Selector Lever Transmission Range Position Display Unit -Y26- -1- is clipped inside the Multimedia System Control Head -E380-.

Removing and installing. Refer to LAMPS .

Courtesy of AUDI OF AMERICA, LLC

A programmed value from the Accelerator Pedal Position Sensor -G79- and Accelerator Pedal Position Sensor 2 -G185- (integrated in accelerator pedal module) are saved in the engine control module as a kick-down signal.

Component location: The accelerator pedal position sensors are integrated inside the accelerator pedal module -arrow-.

NOTE:

The accelerator pedal module must be replaced if the accelerator pedal position sensor is faulty, for the removal and Installation. Refer to ACCELERATOR PEDAL POSITION SENSORS -G79- / -G185-, REMOVING AND INSTALLING [For engine(s) CPNB] .