SUBFRAME Mount Sensor, Removing And Installing: Removing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the front noise insulation. Refer to NOISE INSULATION .

Subframe Mount Sensor 2 -G749- (left side)

-- Remove the rear noise insulation. Refer to NOISE INSULATION .

-- Remove the front left wheel spoiler. Refer to WHEEL HOUSING LINER .

-- Audi RS6/RS7: Remove the nut -arrow- and free up the coolant line -1-.

Courtesy of AUDI OF AMERICA, LLC

-- Loosen bolt -2- and remove the bolts -1 and 3-.

Courtesy of AUDI OF AMERICA, LLC

-- Left lower coolant hose push aside.

NOTE:

Ignore the -arrows-.

Continued for Both Sides

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector -1-.

NOTE:

The :T10405 is required for the left side of the vehicle.

-- Remove the bolt -2- and remove the subframe mount sensor.