Steering Gear, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
-- Install both bolts -1 and 2- loosely at first and then tighten them.
WARNING:
Pull on the steering intermediate shaft -1- to make sure it is secure when the bolt -arrow- is installed. Then tighten the bolt -arrow-.
-- Install the stabilizer bar. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
-- Install the crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .
The "program" J500 Replace Control Module must be started in Guided Fault Finding on the Vehicle Diagnostic Tester if new electromechanical steering gear is installed.
-- Perform an axle alignment. Refer to VEHICLE ALIGNMENT .