Inner Clamp Assembly

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of AUDI OF AMERICA, LLC

-- Install the Tension Rod as shown in the illustration. Make sure that the jaws of the clamp tool are seated in the corners -arrows- of the clamp. Refer to Tensioning the Inner Clamp .

-- Tighten the clamp by turning the spindle using a torque wrench (do not tilt the pliers).

Tightening specification. Refer to Tensioning the Inner Clamp
Use torque wrench with 5 to 50 Nm range (for example, :VAG1331 ).
Make sure the thread on the spindle -1- is easy to move. Lubricate with MoS₂ grease, if necessary.
If the thread is tight, for example, dirty, the required tensioning force for the hose clamp will not be achieved in spite of correct torque specification settings.

Courtesy of AUDI OF AMERICA, LLC

-- Secure the spring clamp -3- on the boot -2- using the :VAG1921 .