Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
- The engine is cold.
-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .
-- Quickly open the coolant reservoir cap -arrow- and release any remaining pressure in the cooling system and then close it again until it locks.
-- Disconnect the connector -2-.
NOTE:
Use a cloth to catch any leaking coolant.
-- Remove the retaining clip -1- and the Engine Coolant Temperature Sensor -G62-.