LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 951 (Engine Cooling System (Service Information - CREC, CREH)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING >> Installing

Engine Coolant Temperature Sensor -G62-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2018 Audi A6 Quattro, 2017 Audi A6 Quattro, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

NOTE:

Replace the O-ring after removing.

To prevent loosing coolant, install the new Engine Coolant Temperature Sensor -G62- immediately into the front coolant pipe.

-- Check the coolant level. Refer to CHECK THE COOLANT LEVEL  and FILLING .

-- Install the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

scientia non olet · About LEMON Manuals