Coolant Fan Control Module -J293- / Coolant Fan Control Module 2 -J671-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front noise insulation. Refer to NOISE INSULATION .
-- Remove the coolant fan connector -1- from the bracket and disconnect it by sliding the retainer back in direction of -arrow- and pressing the release down.
-- Free up the electrical wiring harness to the coolant fan control module.
-- Disconnect the connectors -2 and 3-.
-- Remove the bolt -arrow- and the coolant fan control module -1-.