LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 950 (Engine Cooling System (Service Information - CPNB)) >> 19 Cooling System >> Coolant System/Coolant >> Coolant, Draining And Filling >> Draining

Coolant, Draining And Filling: Draining

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Coolant Draining 

WARNING:

There is a risk of injury if the radiator fan turns on by itself.

  • The coolant fan can come on even when the ignition is turned off, for example, caused by the heat still in the engine compartment.
WARNING:

Risk of scalding due to hot steam and hot coolant.

  • The coolant system is under pressure when the engine is warm.
  • Cover the coolant reservoir cap with a cloth and then open it slowly to release the pressure.

-- Remove the cap -arrow- from the coolant reservoir.

GWWA19-11108Courtesy of AUDI OF AMERICA, LLC

-- Remove the noise insulations. Refer to NOISE INSULATION .

-- Place the :VAS6208  under engine.

GWWA19-11109Courtesy of AUDI OF AMERICA, LLC

-- Remove the drain plug -1- and drain the coolant.

-- Lift the clip -2- and disconnect the coolant hose from the radiator.

-- Loosen the clamp -arrow-, remove the coolant hose from the left front coolant pipe and let the coolant drain out.

GWWA19-11266Courtesy of AUDI OF AMERICA, LLC

Vehicles with Automatic/S tronic Transmission 

GWWA19-11140Courtesy of AUDI OF AMERICA, LLC

-- Remove the right coolant hose from behind, lift the clamp -arrow-, and drain the coolant.