LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2010 >> S4 Automatic DCT >> Repair and Diagnosis >> External Pages >> Different car >> Section 950 (Engine Cooling System (Service Information - CPNB)) >> 19 Cooling System >> Coolant Pump/Thermostat >> Coolant Valve, Removing And Installing >> Check Valve, Removing And Installing, Cylinder Bank 2 (Left) >> Installing

Check Valve, Removing And Installing, Cylinder Bank 2 (Left): Installing

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following: 

NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the parts information.

-- Install the engine support and engine mount. Refer to OVERVIEW - SUBFRAME MOUNT .

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to FILLING .

scientia non olet · About LEMON Manuals