Check Valve, Removing And Installing, Cylinder Bank 1 (Right): Removing
WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Drain the coolant. Refer to COOLANT, DRAINING AND FILLING .
-- Remove the right engine mount. Refer to ENGINE MOUNT, REMOVING AND INSTALLING .
-- When installed: remove the nut -1-, free up the Ground (GND) wire at the right engine support
-- Remove the bolts -arrows- and the right engine support.
NOTE:
Illustrated is the engine support without the heat shield.
-- Remove the bolt -arrow-.
-- Remove the check valve -1-.