Upper Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Replace the O-ring.

Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the parts information.

-- Clean and/or smooth the sealing surfaces of the O-rings.

-- Coat the O-ring with coolant and slide it onto the coolant pipe.

-- Install the intake manifold. Refer to INTAKE MANIFOLD, REMOVING AND INSTALLING .

-- Vehicles with a turbocharger: Install the turbocharger. Refer to TURBOCHARGER, REMOVING AND INSTALLING, VEHICLES WITH A TURBOCHARGER .

-- Connect the coolant hose to the coupling. Refer to Figure.

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to FILLING .