Fan Shroud, Removing And Installing: Installing

WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note the following:

NOTE:

Secure all hose connections with hose clamps of the same type as those equipped by the factory. Refer to the parts information.

-- Install the wires. Refer to RELAY PANELS, FUSE PANELS AND E-BOXES , and refer to the appropriate WIRING DIAGRAM.

-- Install the air guides. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the front bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Connect the coolant hose to the coupling. Refer to Figure.

NOTE:

Do not reuse used coolant.

-- Fill with coolant. Refer to FILLING .