Lower Front Coolant Lines, Removing And Installing: Removing
WARNING: This page is about a different car, the 2018 Audi S6, 2017 Audi S6, and 2016 Audi S6. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the front noise insulation. Refer to NOISE INSULATION .
-- Remove the lower front right longitudinal member. Refer to LOCK CARRIER .
-- Remove the front bumper cover end plate. Refer to BUMPER COVER, REMOVING AND INSTALLING .
-- Remove the nut -arrow- and free up the coolant line -1-.
-- Place the :VAS6208 under separating point.
-- Remove the clamp -1- and loosen hose clamp -3- to disconnect the coolant hose and drain the coolant.
-- Remove the bolt -4- and remove the supports from the coolant pump.
-- Loosen hose clamp -arrow-, remove the front and right coolant lines.