Coolant Pump, Removing And Installing: Installing
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi A6 Quattro, 2017 Audi A6, and 2016 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal and Note The Following:
- Used coolant cannot be used again.
-- Install the coolant pump -1- and toothed belt.
-- Pay attention that the centering piece -arrows- and seal -3- are seated correctly.
-- Tighten the coolant pump bolts. Refer to Figure.
-- After installing a new coolant pump -2-, remove the protective cap -1- from the drive wheel.
-- Fill with coolant. Refer to COOLANT, FILLING .
Additional procedures. Refer to BLEED COOLING SYSTEM and COOLANT LEVEL, CHECKING (COOLANT PUMP, REMOVING AND INSTALLING ) .