Metal Valve Body, Removing And Installing
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1410:VAG1410 and Torque Wrench 1331 5-50Nm :VAG1331 11 mm.
-- Place the metal valve with rubber seal through rim from inside.
-- Attach chamfered washer and union nut from outside and tighten by hand.
-- Tighten the union nut.
NOTE:
Be careful not to scratch off the glued- on wheel trim on these rims.
The surface of the wheel trim is very sensitive.
The rim will have be replaced if the wheel trim is damaged.
The wheel trim cannot be replaced.
-- Secure against turning with counterhold -1- (for example, a 2 mm drill bit).