Rear Axle Camber, Adjusting
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the nut -A- of threaded connection of wheel bearing housing/control arm, and screw on new nut until stop.
-- Adjust the camber by rotating the adjusting bolt -B-. To turn the adjusting screw -B-, turn the hex head at the >>top of the screw<<.
Axle alignment specified values. Refer to AXLE ALIGNMENT SPECIFIED VALUES .
NOTE:
The Maximum Adjustment Range Is 135° To Left Or Right Of Center Position.
Do Not Rotate The Adjusting Bolt -B- Further Once The End Position Has Been Reached Or The Components Will Be Damaged.
For A Better Illustration, Camber Adjustment Is Shown With Wheel Removed.
-- Tighten nut -A- -Item 13) OVERVIEW - TRANSVERSE LINK .
-- After tightening nut -A-, check camber value once more. Refer to AXLE ALIGNMENT SPECIFIED VALUES .