Axle Alignment Control Position On Vehicles With Air Suspension, Checking

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2018 Audi S6, 2018 Audi A6 Quattro, 2018 Audi A6, 2017 Audi S6, and 2017 Audi A6 Quattro. However, it is still accessible from the selected car via links, so may be relevant.

Axle Alignment Control Position, Checking

Before performing an axle alignment on a vehicle with air suspension, check the curb weight or control position and adapt it again if necessary.

-- Start the >>axle alignment<< using the Vehicle Diagnostic Tester in Guided Functions .

Determining The Height Dimension -a-

Courtesy of AUDI OF AMERICA, LLC

Height Dimension -a- Is The Measurement In Mm Between Center Of Wheel And Lower Edge Of Fender.

-- Determine dimension -a- between the center of the wheel and the lower edge of the fender/wheel housing as illustrated.

Height Dimensions Overview

SPORTBACK

Suspension	Level	Distance Between the Center of the Wheel and the Lower Edge of the Fender/Wheel Housing
		Front Axle	Rear Axle	Tolerance between the right and left
		Nominal dimension	Drift	Tolerance between the right and left	Nominal dimension	Drift
Standard suspension 1BK	Normal	386 mm	± 10 mm	384 mm	± 10 mm	<= 10 mm
RS suspension (2MA)	Normal	386 mm	± 10 mm	384 mm	± 10 mm	<= 10 mm
Sport suspension 2MB	Normal	386 mm	± 10 mm	384 mm	± 10 mm	<= 10 mm
Heavy duty suspension 1BS	Normal	391 mm	± 10 mm	389 mm	± 10 mm	<= 10 mm

SEDAN/AVANT

Suspension	Level	Distance Between the Center of the Wheel and the Lower Edge of the Fender/Wheel Housing
		Front Axle	Rear Axle	Tolerance between the right and left
		Nominal dimension	Drift	Tolerance between the right and left	Nominal dimension	Drift
Standard suspension 1BK	Normal	384 mm	± 10 mm	382 mm	± 10 mm	<= 10 mm
RS suspension (2MA)	Normal	384 mm	± 10 mm	382 mm	± 10 mm	<= 10 mm
Sport suspension 2MB	Normal	384 mm	± 10 mm	382 mm	± 10 mm	<= 10 mm
Heavy duty suspension 1BS	Normal	389 mm	± 10 mm	387 mm	± 10 mm	<= 10 mm
allroad 1BY	Normal	393 mm	± 10 mm	390 mm	± 10 mm	<= 10 mm